Ethernet Switch Installation Instructions:
 |
| Figure 2.1 Dynex 8 Port 10/100 Fast Ethernet Switch |
- Plug the Dynex Fast Ethernet Switch power adapter into the back of the device and connect the other end into a power strip or wall outlet. Red power light should appear.
 |
| Figure 2.2 Unshielded Twisted Pair (UTP) CAT 5 |
- Connect the UTP Cat 5 into the rear of the Ethernet switch.
 |
| Figure 2.3 CAT 5 connected to Internet port |
- The other end of this UTP Cat 5 should connect to the Internet port on the wall. A green light will appear on the front side of the Ethernet switch to show an active connection.
 |
| Figure 2.4 Power strip with Ethernet and computer plug-ins |
- Plug power cords from the three desktop computers into the power strip. Turn the computers on.
 |
| Figure 2.5 UTP cables connected to Ethernet ports |
- With the remaining three UTP CAT 5 cables, connect one end of the cord into a port on the rear of the Ethernet Switch.
 |
| Figure 2.6 CAT 5 cabling connected to eMac Ethernet port |
- The other end of each cord should be plugged into the Ethernet port on the three different computers.
 |
| Figure 2.7 eMac with Internet access |
- An active network connection should be made.